Open Shop Day ....

[McMahonRacing]

Holding an Open Shop Day w/ the FF Cobra forum members, not a huge shop more of a winter get together and a change of pace from the typical breakfast runs, if your in the area and interested swing in …….

Sunday 31st
9am til .....
334 Long Pond Rd
Danville NH 03819

Will have:

Coffee/Juice/soda/water/hot choc/ etc etc
Donuts/pastry/muffins/etc

Feel free to swing in and shoot the breeze.
Pat

Code: Select all

[John F]

OK, I don't have to post on the cobra forum to find out if this is still going on. See you Sunday

Maybe you can have the Rolex 24 going? I don't get speed anymore

[McMahonRacing]

Will be on in the house ..... shop only get's DVD's !!!

[breakaway500]

Got heat in that shop,or am I going to wear my ski outfit?

What's the best way to get there off 495.. 125 to old coach rd. to mill rd. to cheney rd?

[jlwhorf]

Hey Mark, if you are driving up, you can stop by my place. It is only about 10 minutes away from Pat's and on the way.

[paultg]

Cool, you are only 30 mins or so from me, I might swing by.

Thanks!

[McMahonRacing]

Will be 60f min, can turn it up if you need !!!!

There are a couple ways .. from Rutland I usually run down Rt 2- Rt 495 N - Rt 125 N or you can run Rt 93 N too Rt 111 E ... not much time difference, just more traffic on Rt 125 !!!!!

There is also a senic route, following Rt 111 to Amherst Flea Market, down to Hollis but I have to do that by braille !!!!

Everyone is welcome so swing on in !!!!

[breakaway500]

Sunday a.m. traffic should not be bad on 495..I'll probably do the 125 etc route.. I may take a side trip up to Kittery first as I have not been in a while and I don't get out of my cave very often... (running low on ammo...) Hey, need some wood for the fireplace?

[McMahonRacing]

If you run to Kittery first ..... consider Rt 101 E or Rt 107 E off Rt 95 S over too Rt 125 ..... we typically cut over on Rt 107 on the way back from Caribou .... Pat

[breakaway500]

Thanks,Pat. C-U Sundaaaaaaaaaaay!

[McMahonRacing]

Guys .... Just wanted to pass along a quick Thanks for visiting today ...... enjoyed it ...... Thans Again ... Pat

[breakaway500]

Had a great time as well,and thanks for the TIG welder! That was a wonderful door prize..

[John F]

Had a great time as well,and thanks for the TIG welder! That was a wonderful door prize..

Who took my V710's?