COM Sports Car Club

These are all new/sealed from Mazda.

Oil Dipstick 1.8L: Part #BPE8-10-450: $10

Upper Timing Cover Gasket: Part#B660-10-522: $8

Freeze Plug Set for 1.8L, I think some of these carry over to 1.6L blocks. I'd like $15 for the entire set.
(2) Plug #0221-10-327
(3) Cap # 9930-63-000
(2) Cap # 9930-63-500

Also order this thinking I needed it and did not. It's an inner tie-rod set for 90-93 1.6L (not sure if it carries over 94-97 model or newer). Cost me $95 + shipping, lets say $85. These are the part numbers:
Ball joint #NA02-32-240
Washer #NA02-32-126
Book, Rack #NA02-32-125

I'll take the dipstick...mine has no handle anymore...

jeffw wrote:I'll take the dipstick...mine has no handle anymore...

Mine neither but they all break off...

Sounds good Jeff. I'll pack it with my track stuff for NHMS1.

jeffw wrote:I'll take the dipstick...mine has no handle anymore...

Sorry to hear that Jeff. I am 71 and still have a handle on the dipstick.

Gross.

Just a reminder, those 1.8 dipsticks (and dipstick tubes) come in a couple of different lengths. Don't mix and match!

<<insert gross comment by Sam here>>

I've already had issues with a dipstick that was the incorrect length

Thanks for the reminder.

I've been running a 1.6L dipstick in my 1.8L, they seem to be the same length and it reads correctly when I fill the oil, which is why I didn't use it.
I'll pack this up Jeff and bring it to NHMS (after I check it again since Will has me paroniod now!).

Paul G.